Ordering was simple, shipping was fast; they had notified me right away that I had accidentally keyed in a wrong credit card number. Once I had given them the correct number, my order was processed right away. Will order again from this company.
Provide Pure Sine Wave power to trucks, boats, remote job sites or emergency/backup power applications with the Tripp Lite APS2012SW DC-to-AC Inverter/Charger. Featuring an automatic line-to-battery transfer switch and an integrated charging system, this inverter/charger can operate as an extended-run UPS, a standalone power source or an automotive inverter. The APS2012SW can supply 2000 watts of continuous 120V AC power from any 12V battery or automotive DC source. It supports an unlimited amount of runtime with any number of user-supplied batteries. Its heavy-duty, 3-stage, selectable, 6/60amp, wet/dry cell battery charger will properly charge your vehicle battery or separate battery bank. Since many power tools, appliances and motors require more power at startup or during cycling, the APS2012SW is designed to deliver up to 200% of its continuous output rating(4000W of peak power) for up to 10 seconds to accommodate this peak power demand. A reliable large transformer design with frequency control makes it capable of powering resistive electronic loads as well as inductive loads such as motors, compressors, pumps, heavy-duty power tools and other appliances. When a 120V AC cable is connected to the APS2012SW, it functions as a UPS with utility power passing through the unit to connected equipment while the battery pack is being recharged. In UPS mode, the APS system responds to blackouts and voltage fluctuations with a near instantaneous, automatic transfer to provide reliable battery backup power to connected equipment. A set of high current DC input terminals is included for simple, hardwired installation.(See the owner's manual for recommendations on installing user-supplied batteries and cabling.) For a remote inverter on/off switching capability, an optional remote power switch module with full status LEDs is available for installation(APSRM4 sold separately).
NOTE: To protect against high current draw that may occur during inverter failure, a fuse link rated at 400A should be positioned no more than 18 in. from the APS2012SW's battery in the positive line.
|Manufacturer Part Number:||APS2012SW|
|Manufacturer Website Address:||http://www.tripplite.com|
|Brand Name:||Tripp Lite|
|Product Name:||PowerVerter APS2012SW Power Inverter|
|Product Type:||Power Inverter|
|Plug/Connector Type:||Terminal Block|
|Input Voltage:||12 V DC, 120 V AC|
|Output Voltage:||120 V AC|
|Load Capacity:||2 kW Continuous Power / 4 kW Peak Power|
|Waveform Type:||Sine Wave|
|Switching Time:||10 ms|
|Height:||20.4" (518.2 mm)|
|Width:||8.8" (223.5 mm)|
|Depth:||7.2" (182.9 mm)|
|Limited Warranty:||1 Year|